Hello members,
Need you all help and support..I'm working with Mitsubishi PLC CPU type Q06H Series. In my system there have 2 master cclink.
1st master : Using for robotics system networking
2nd master : Using for jig fixture system networking.
For 1st master CClink, I setting baud rate 5 Mbps. Signal send receive is good.
But, for 2nd master, i need to set 625 kbps. If set more than this seting, communication error will occur for 2nd master CC-link.
Wiring configuration :
1st master : all cclink cable loop from master to remote I/O then 1 resistor (110 Ohm/0.5W) terminate at master and 1 more at last station in remote I/O. ( I think this wiring configuration is no problem).
2nd master : all cclink cable loop from master to remote I/O. no resistor using in this connection. If using resistor, only baud rate 156kbps can use. So, last station ( should be using resistor)i make looping cclink cable to master cc-link ( also should use resistor ) . iF this method use, cclink baud rate can set until 625 kbps.
---> In this wiring I using connector 4 pin from station to next station...Normally, should be direct terminate to remote I/O all CC-link cable.
So, my question is, any effect because of noise i using connector to terminate cclink cable in this wiring..
I want to set 2nd master 5Mbps..what i need to use ?...
Need you all help and support..I'm working with Mitsubishi PLC CPU type Q06H Series. In my system there have 2 master cclink.
1st master : Using for robotics system networking
2nd master : Using for jig fixture system networking.
For 1st master CClink, I setting baud rate 5 Mbps. Signal send receive is good.
But, for 2nd master, i need to set 625 kbps. If set more than this seting, communication error will occur for 2nd master CC-link.
Wiring configuration :
1st master : all cclink cable loop from master to remote I/O then 1 resistor (110 Ohm/0.5W) terminate at master and 1 more at last station in remote I/O. ( I think this wiring configuration is no problem).
2nd master : all cclink cable loop from master to remote I/O. no resistor using in this connection. If using resistor, only baud rate 156kbps can use. So, last station ( should be using resistor)i make looping cclink cable to master cc-link ( also should use resistor ) . iF this method use, cclink baud rate can set until 625 kbps.
---> In this wiring I using connector 4 pin from station to next station...Normally, should be direct terminate to remote I/O all CC-link cable.
So, my question is, any effect because of noise i using connector to terminate cclink cable in this wiring..
I want to set 2nd master 5Mbps..what i need to use ?...