Hi all,
I am totally new when it comes to anything with PLCs, so please excuse my ignorance.
We recently had our PanelView+ 1000 (2711p-RDT10C) (SER:B) screen go bad. It was mated to a Logic Module: 2711PCRP1 (SER:G).
We ordered a new panel and logic module. when the order arrived we installed it but the program was on the old module. we swapped our old module onto the new PV+ and fired it up. It instantly powered up with our program running. The problem is that after about 30 seconds an alert pops up on the screen, it shows a hand with a line through it. It also instantly shows a fault on logic module. I have tried plugging a mouse in, but it will not allow any input once it alarms.
Does anyone know what is wrong or what i did wrong?
Thanks, Jeremy
I am totally new when it comes to anything with PLCs, so please excuse my ignorance.
We recently had our PanelView+ 1000 (2711p-RDT10C) (SER:B) screen go bad. It was mated to a Logic Module: 2711PCRP1 (SER:G).
We ordered a new panel and logic module. when the order arrived we installed it but the program was on the old module. we swapped our old module onto the new PV+ and fired it up. It instantly powered up with our program running. The problem is that after about 30 seconds an alert pops up on the screen, it shows a hand with a line through it. It also instantly shows a fault on logic module. I have tried plugging a mouse in, but it will not allow any input once it alarms.
Does anyone know what is wrong or what i did wrong?
Thanks, Jeremy