PlasticsMan
Member
I have 2 Dataliner DL50 displays (2706-F11J) that are driven from an AB 5/03 PLC. Its old school but works very well for being in service for ~15 years. I purchased a used DL50 to add to the system and unfortunately it has some bugs. I set it up just like the other two and connected it to the RS-485 cable, but the new display behaves differently; there's an odd character preceding the message and the message scrolls one pass then remains. Bear in mind the other two displays work flawlessly and do not do this.
The only difference I see is the firmware. My existing ones have 2.01 and the newly added one is 1.01
Would the older firmware cause this bug? Anyone have the firmware I need? (hoping someone has an old dust covered floppy)
On a side note, the power filter is hissing.... Hmm... Noise?
The only difference I see is the firmware. My existing ones have 2.01 and the newly added one is 1.01
Would the older firmware cause this bug? Anyone have the firmware I need? (hoping someone has an old dust covered floppy)
On a side note, the power filter is hissing.... Hmm... Noise?